![]() ![]() Repository OPNsense has no meta file, using default settingsĪ firmware update is currently in progress.Īny help on this would be greatly appreciated. Pkg-static: Repository OPNsense load error: access repo file(/var/db/pkg/repo-OPNsense.sqlite) failed: No such file or directory I’m on a ppp link traceroute() does not work. Getting ‘failed to set hardware filter to promiscuous mode’ error Scapy says there are ‘Winpcap/Npcap conflicts’ BPF filters do not work. This will automatically fetch all available updates, apply them, Scapy does not work with 127.0.0.1 (or ::1) on the loopback interface. Configured Loopback in all the routers and advertise in BGP. I have configured BGP on all the routers are R1 and R3 & R3 and R4 are the neighbor of each other. I am sure they are related somehow and probably due to a missing route or firewall issue, but I cannot seem to find any faults or help on this issue. Also, when I try to update or download the package list it fails stating it cannot reach the host, and it would seem a file is missing. Pinging shows the IP is resolved but uses the Loopback port to ping. So, what is happening is that whenever I run a trace route from Shell or the WUI, all hops are the loopback port. I have found 3 issues that seem to be related but I cannot seem to figure out what is wrong. I turned off the Firewall, and chose 'Use Windows Recommended Settings', then the Firewall is turned on again. i have enable IP routing on both switches. Currently, I am able to ping the loopback interface on switch 1 but not on switch 2 from any computer in the 2 VLANS i created. Im trying to configure loopback interfaces on (2) 3560 Multilayer switches that i can ping from any computer. I have found a few minor things such as creating a firewall rule to allow access to the firewall remotely and allow the firewall to ping. 11-30-2018 12:51 PM - edited 03-08-2019 04:43 PM. I am very happy so far with setup and overall ease of use of the web interface. I have previously used Pfsense (Until hardware failure.) I was hearing OPNsense 17.7 is more secure and such. When using the Broadcom Control Suite, I can successfully ping the ISP address but the diagnostic tests show a MAC and PHY Loopback Test failure. I uninstalled the ethernet software and reinstalled it. I am completely new to OPNsense, IE this is my first install. Broadcom 440x 10/100 Integrated Controller. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |